Module 4 Assignment – Safety Analysis Presentation
Assignment
Task: Submit to complete this assignment
Purpose: The purpose of this presentation is to analyze a patient safety concern in your practice setting. This presentation should be of the quality that it could be presented to leadership in your practice setting.
Instructions:
Create a PowerPoint presentation of no more than sixteen slides that includes all of the following:
1. Title Slide
2. Safety Issue Identification
• Identify one patient safety issue that is the most relevant to your practice • Give the rationale for its importance and potential impact on patient safety
• Answer the questions on page 210 in the Spath text: What can go wrong?
What will be the result if something goes wrong?
What needs to be done to prevent a bad result when something does go wrong?
2. Analysis
Use the Failure Mode and Effect Analysis process steps presented on page 210-213 OR the Root Cause Analysis process steps on page 213-216 to analyze the process involved in the issue.
• Provide a rationale for the process selected
• Present a slide for each step of the chosen process, proposing what you would do and provide evidence from the literature to support your analysis and interventions
3) Patient Engagement
Propose how patient engagement could contribute to the prevention of this issue and how you could promote that engagement (See Spath pages 222-223)
4) Considering the discussion on reliability in Spath chapter 9 and exhibit 9.2 on page 235, propose process changes that could be implemented to achieve:
80-90 percent reliability, 95 percent reliability, 99.5 percent reliability. What would the goal be for each level and how would you measure the effectiveness and achievement of the goal. 5) References
Include at least two journal resources for each area above (8 minimum), one in each section should be a nursing-specific journal.
Cite each source on the bottom right of the slide where it is used
The presentation should also contain a title slide and a reference slide page in APA format.
Each citation and reference should be peer-reviewed, published within the last 5 years, and in APA 7th edition. the book is : Spath, P. L. (2023). Introduction to healthcare quality management (4th ed.). Health Administration Press.
*****Also, module 1 will tell you my quality issue in the practice setting I added so you can see.